Connect Ductwork (Ducted Configuration Only) - Kenmore Elite 233.5230 Serie Manual De Uso Y Cuidado

CONNECT DUCTWORK (ducted configuration only)

1. Adjust the width of the flue mounting bracket
assembly to equal the inside width of decorative
flue. Insert and tighten mounting screws (3,9 X 6
mm) to hold bracket width.
2. Use mounting screws (4,8 x 38 mm) and wall
anchors to secure flue mounting bracket to the
ceiling as shown.
FLUE
MOUNTING
BRACKET
ASSEMBLY
All manuals and user guides at all-guides.com
MOUNTING
SCREWS
(3,9x6mm)
WALL
ANCHORS
MOUNTING
SCREWS
(4,8x38mm)
3. Use 6" round damper / duct connector to 6"
discharge on hood.
4. Attach 6" round metal duct to connect the duct
collar on the hood to the ductwork above.
5. Use duct tape to make all joints secure and air
tight.
6. Insert the decorative flues setting them on the
hood.
7. Extend the upper flue to the ceiling and secure
with two mounting screws (3,9 x 9,5 mm).
UPPER
FLUE
LOWER
FLUE
9
DECORATIVE
FLUE
DUCT TAPE
6" ROUND
METAL
DUCT
FASTEN FLUE TO
UPPER BRACKET
WITH MOUNTING
SCREWS
(3,9x9,5mm)
LOUVERS
ON UPPER
FLUE (Slide
down, inside
of lower
flue)