Descargar Imprimir esta página

Uline H-8348 Manual Del Usuario página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Insert inner leg tubes into side panels and place at
desired height. Using a Phillips screwdriver, attach
inner leg tube to side panels by inserting two
M6 x 12 mm bolts into threaded holes. (See Figure 2)
NOTE: Height is adjustable from 29-35⁄" in 1⁄"
increments. Tabletop adds 1" to overall height.
Figure 2
M6 x 12 mm Bolt
Left Side
Panel
Inner Leg Tube
3. Attach back panel to each side panel with six
M6 x 12 mm bolts and six M6 nuts using a Phillips
screwdriver. (See Figure 3)
Figure 3
Back Panel
4. Attach front support channel to each side panel by
inserting two M6 x 12 mm bolts into threaded holes.
(See Figure 4)
Figure 4
M6 x 12 mm
Bolt
PAGE 2 OF 15
ASSEMBLY CONTINUED
Right Side
Panel
M6 x 12 mm
Bolt
M6 Nut
Front Support
Channel
5. Place laminate top upside down on a smooth,
non-marring surface to prevent scratching.
Pre-drilled holes in laminate top should be facing up.
6. Carefully flip table frame over and place on top of
laminate top. Carefully align the mounting holes
in table frame and pre-drilled holes in laminate top.
Using a drill, attach table frame to laminate top with
10 self-tapping screws. (See Figure 5)
Figure 5
Self-Tapping
Screw
Laminate Top
7.
Once laminate top is attached, flip table back over
onto its feet.
8. Insert middle shelf supports at desired height.
(See Figure 6)
NOTE: Middle shelf is optional and can be
attached at a later time.
Middle Shelf
Support
Figure 6
9. Insert middle shelf with cut sections facing back
corners of table frame. Middle shelf will rest on top
of middle shelf supports. (See Figure 7)
Figure 7
Middle
Shelf
0721 IH-8348

Publicidad

loading