Uline H-8348 Manual Del Usuario página 4

3. Once doors are correctly positioned in both sliding
door channels, attach bottom sliding door channel
to front half lower shelf with four M5 x 10 mm
countersunk screws and four M5 nuts using a Phillips
screwdriver. (See Figure 13)
Figure 13
M5 x 10 mm
Countersunk Screw
M5 Nut
4. Assembly is complete.
MAIL SORTER WORKSTATION ASSEMBLY
PARTS FOR MAIL SORTER WORKSTATION ASSEMBLY
Mail Sorter x 2
1. Complete Table Frame Assembly starting on page 1.
2. Place one mail sorter on rear of laminate top.
3. Attach five mounting brackets to mail sorter with five
M6 x 10 mm bolts and M6 nuts. Fasten mounting
brackets to laminate top with five self-tapping
screws using a drill. (See Figure 14)
NOTE: Two mounting brackets will be attached
to each side and three will be attached to back.
Figure 14
Second
Mail
Sorter
Mail
Sorter
Mounting Bracket
PAGE 4 OF 15
ASSEMBLY CONTINUED
M6 x 10 mm M6 Nut x 12
Bolt x 12
M6 x 10 mm Bolt
M6 Nut
M6 x 10 mm Bolt
M6 Nut
Self-Tapping
Screw
4. Stack second mail sorter on top of attached mail
sorter. Fasten mail sorters together with six M6 x 10 mm
screws and M6 nuts using a Phillips screwdriver. Holes
are located in front and rear of sorters on far left,
center, and far right columns. (See Figure 14)
NOTE: Mail sorter shelves may need to
be removed to allow for space for Phillips
screwdriver to fully tighten screws and nuts.
5. Assembly is complete.
MAIL SORTER WORKSTATION WITH RISER
ASSEMBLY
PARTS FOR MAIL SORTER WORKSTATION WITH
RISER ASSEMBLY
Top Panel x 1
Back Panel x 1
Mail Sorter x 2
1. Complete Table Frame Assembly starting on page 1.
2. Place riser top panel upside down on a smooth,
non-marring surface to prevent scratching.
3. Attach right side panel by inserting locking tabs into
matching square holes on top panel. Gently tap
with a rubber mallet to fully engage tabs. Repeat for
left side panel. (See Figure 15)
NOTE: Locking tabs can be adjusted open or closed
with a flathead screwdriver for easy assembly.
Right Side
Figure 15
Left Side Right Side
Panel x 1 Panel x 1
Front Support Channel x 1
M6 x 12 mm M6 x 10 mm
Bolt x 12 Bolt x 12
Left Side
Panel
Panel
M6 Nut
x 26
0721 IH-8348