Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Please take note of the following important points when installing.
• Do not install the unit where leakage of flammable gas may occur.
If gas leaks and accumulates around the unit, it may cause fire ignition.
• Do not overcharge the unit.
This unit is factory pre-charged. Overcharge will cause over-current or damage to the compressor.
• Sharp edges and aluminium fin coil surface are potential location which may cause injury
hazards. Avoid from being in contact with these locations.
•
The unit should be lifted using a crane. Ensure that the hanger belts are not touching panel
and the coil, top front panel (use protective panel) as shown in Figure 1.
•
The bolt of the base and channel support can be removed after putting the unit on the fixed
location.
•
Installation work should be done by the authorized dealer or qualified contractor.
•
Make sure there is sufficient airflow around the unit.
•
Vibration isolator should be provided to prevent vibration and noise from the unit.
•
There should be sufficient space allocated for servicing and maintenance.
All manuals and user guides at all-guides.com
INDEX
page i
page 1
page 1
page 2
page 2
page 3
page 3
TRANSPORTATION
INSTALLATION LOCATION
1-1
page 3
page 4
page 5
page 6
page 7
page 8
page 9
Hanger
Hanging Belt
Protective Panel
Figure 1
Publicidad
Capítulos
Tabla de contenido
