1.
Make sure all items listed on the front of
this guide are included in the box.
2.
READ SAFETY INSTRUCTION BOOKLET
BEFORE USING THE PRODUCT.
3.
Study this setup diagram.
4.
Place mixer in an appropriate position for
operation.
5.
Make sure all devices are turned off and all
faders and gain knobs are set to "zero"
6.
Connect all stereo input sources as
indicated in the diagram.
7.
Connect the stereo outputs to power
amplifier(s), tape decks, and/or other audio
sources.
8.
Plug all devices into AC power.
1.
Phono Inputs: This input is used for connecting
your turntables through the sensitive RIAA phono
preamplifiers. Only turntables with phono level
output should be attached. Line level turntables
must be attached to the line inputs.
2.
GND: This screw connector should be used to
secure any turntables or other devices connected
to the mixer that need to be grounded.
3.
Line Inputs: CD players, Tape Decks, Samplers
or other line level input devices should be
connected to these inputs.
4.
Microphone Input: Microphones with a ¼"
connector can be connected to these input
terminals.
5.
Fader Start Connector: to attach your mixer to
a remote start equipped Numark CD player using
industry standard 1/8"(3.5mm) cables.
6.
Record Output: This RCA output is for
connecting a recording device such as a tape
deck or CD recorder. The level of the record
output is based upon pre-master levels.
7.
Zone Output (RCA): This output is for
connecting an external monitoring device such as
a PA system, powered monitors or a home
stereo. The level of the zone stereo output signal
is controlled by the zone fader.
8.
Master Output (RCA): This output is for
connecting an external monitoring device such as
a PA system, powered monitors or a home
stereo. The level of the master stereo output
signal is controlled by the master fader.
9.
Stereo Balanced Master Outputs (XLR): low-
impedance XLR type connectors controlled by the
Master fader.
10. AC In: This mixer is designed to work with the
power supply cord that comes with the unit.
While the power is switched off, plug the power
supply into the mixer first, then plug it into the
outlet.
11. Voltage Selector: Set this to the correct voltage
for your location standard.
12. Power Switch: Use this switch to turn on the
mixer after all input devices are already
All manuals and user guides at all-guides.com
MIXER QUICK SETUP
REAR CONNECTIONS
9.
Switch everything on in the following order.
•
audio input sources (i.e. turntables or
CD players)
•
mixer
•
last, any amplifiers or output devices
10.
When turning off, always reverse this
operation by,
•
turning off amplifiers
•
mixer
•
last, any input devices
11.
Go to
http://www.numark.com
registration.
More information about this product may be
found at
http://www.numark.com
connected to prevent damage to your equipment.
Turn the mixer on before you turn on amplifiers
and turn of amplifiers before you turn off the
mixer.
13. USB Jack: This sends and receives audio data
from your computer. The USB A jack sends
audio to the mixer's channel 3, while the USB B
jack sends audio to channel 4. See the separate
instructions for how to use your USB mixer with a
computer.
14. USB Output Select Switches: These switches
select what signal is output through each USB
jack. For the USB A jack, you can output either
the Record output signal, or a direct output of the
signal going into channel 3. For the USB B jack,
you can output either the Master output signal,
or a direct output of the signal going into channel
4. The direct output settings are pre-fader, with
no effects applied to the signal.
for product