Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
HOW TO pERFORM THE pATCH TEST
Since the skin tone and its sensitivity vary from one body part to another, a
patch test should be performed on each part of the body that is to be treated.
•
First check the tone of your skin by comparing it to the table on the package
and in the instruction manual.
•
Identify a small area that is to be treated.
•
Shave the area that is to be treated.
•
After having set the lowest power level, apply the handpiece to the area
and emit the first pulse. If no discomfort is felt, increase the power to the
next level, move the handpiece to the adjacent skin area and emit another
pulse. Increase the power level on each subsequent area of skin until the
maximum tolerable level for the skin type. A feeling of heat can be felt on
the skin during the treatment, and this is normal. If discomfort is felt, the
maximum tolerable power level is the previous one.
•
Check the area after 24 hours: if the redness persists, the maximum
tolerable power level for your skin type is the previous one.
Even though it is extremely rare, if hypersensitivity should persist for over 24
hours, it is recommended to consult a doctor.
ATTENTION: the power output directly affects the result, however, due to the
principle of heat of the treatment, the maximum limit tolerated by your skin
must not be exceeded. This limit is normally high for fair skin and low for dark
skin because melanin that darkens the skin increases the production of heat.
Do not exceed the maximum limit that your skin tolerates with no discomfort
whatsoever.
78
pREpARING THE AREAS THAT ARE TO BE TREATED
•
The skin must be shaved, clean, dry, with no make-up, anti-perspirant
or deodorant.
•
On the face, if the dark hair to treat is sparse and there is little of it, you don't
need to shave the area; simply trim the hair with scissors. If the hair is very
short (about 1mm) and not too thick, you don't need to shave or trim them.
•
Moles, birthmarks, dark spots, tattoos and lips must be covered with a
white pencil or white patches.
ATTENTION: Before starting the treatment, carefully read the paragraphs
concerning: safety warnings, contraindications, precautions for safe use,
possible side effects, treatment areas and hair removal program.
pREpARING THE AppLIANCE
1.
Remove the appliance and the other components from the package.
2.
If the appliance is stored in a very cold place, wait for it to reach at least 15 °C.
3.
If the plug has not been inserted into the adaptor (7), hold
the latter, pull the "Open" key downwards and insert the
plug (7A, 7B or 7C), which is suitable for the socket of
the electrical system, into the relative slot.
4.
Insert the cable of the adaptor (7) into the power supply
connection (3).
5.
Insert the adaptor plug (7) into a socket: all the LEDs on the control panel
(5) will go on and off repeatedly in a circular sequence.
USE
EN
79
Publicidad
Tabla de contenido
