Matco Tools RS499 Guia De Inicio Rapido página 2

ALWAYS wear eye protection that meets ANSI Z87.1 and OSHA standards.
ALWAYS refer to the vehicle and engine specific manuals before doing any job.
This tool is NOT intended for non-Ford applications.
Images contained herein may not represent the actual vehicle.
This tool is meant to be used by professionally trained technicians.
NEVER strike, heat, attempt to alter or use this tool other than it's intended purpose.
NOT INTENDED for use with pneumatic or other high impact tools.
Failure to comply with these rules will immediately VOID the manufacturer's warranty.
Seal Removal
1. Remove the bolts (5) from the rear seal
retainer as shown.
2. Clean all the RTV silicone from the sealing
surface but be careful not to damage the
crankshaft or surface.
Wear Sleeve Removal (if equipped)
1. Insert the Centering Force Screw into the
Threaded Adapter.
2. Arrange the (3) Remover Plates over the
wear sleeve.
3. Place the Threaded Adapter and Centering
Force Screw so all Remover Plates are in
grove of the Threaded Adapter.
4. Slide the Sleeve Ring over the (3) Remover
Plates.
5. By hand, bottom out the Centering Force
Screw on the Crankshaft.
6. Turn the Centering Force Screw clockwise
to remove the wear sleeve.
www.matcotools.com
Figure A
Seal Housing
Crankshaft Flange
Figure B
Sleeve Ring
Parts List No. 8
Remover Plates
Parts List No. 7
(Three Required)
Threaded Adapter
Parts List No. 6
C. Force Screw
Parts List No. 2
Remover Plates
Parts List No. 7
(Three Required)
Threaded Adapter
Parts List No. 6
Centering Force Screw
Parts List No. 2
Sleeve Ring
Parts List No. 8
Wear Sleeve
Page 2