Final Assembly - Matco Tools RS499 Guia De Inicio Rapido

Seal / Wear Sleeve Installer Assembly
1. Thread the hex nut onto the Force Screw.
2. Thread the Force Screw with the Hex Nut
into the Seal Installer.
3. Put the Sleeve Ring over the Seal Installer.
Installing Seal and Wear Sleeve
NOTE: Optionally, a light layer of a
non-hardening sealant, e.g. Loctite 209, can
be applied to the inside diameter surface of
the sleeve. Clean away sealant that migrates
to the shaft or sleeve outside diameter
surface.
1. Put the Seal Installer and Sleeve Ring
against the seal and wear sleeve, over the
Centering Plate. Thread the Force Screw
into the Centering Plate.
2. Turn the Hex Nut, bringing it in contact
with the Seal Installer.
3. Continue to tighten the Hex Nut, pressing
the seal and wear sleeve into position.

Final Assembly

1. Tighten the seal housing bolts to the
manufacturer's specifications.
www.matcotools.com
Figure F
Seal Installer
Parts List No. 4
Force Screw and Hex Nut
Parts List No. 1 and No. 5
Sleeve Ring
Parts List No. 8
Figure G
Seal Installer
Parts List No. 4
Centering Plate
Parts List No. 3
Force Screw and Hex Nut
Parts List No. 1 and No. 5
Sleeve Ring
Parts List No. 8
Figure H
Seal Housing
Crankshaft Flange
Page 4