All manuals and user guides at all-guides.com
Programming For DVD
Most GE, RCA and ProScan DVD systems
will not require programming. Check to see
if your DVD system responds to the remote
before you begin programming.
1. Manually turn on the DVD system. Find
the three digit code for your DVD system in
the code list below.
2. Press and hold the
CODE SEARCH button
until the INDICATOR
LIGHT lights, then
release the CODE
SEARCH button.
3. Press and release
the DVD button (The
INDICATOR LIGHT
will blink then remain
lit.
4. Enter the code
using the Number
Buttons. After your
code is entered, the
INDICATOR
LIGHT will turn off. If
the code is not valid, the
INDICATOR LIGHT will
blink. Check the code
list and repeat process.
5. Aim the remote at
your DVD system and
press the ON•OFF but-
ton. Your DVD system
should turn off.
6. If the DVD System responds, no further
programming is required.
NOTE: If your DVD does not respond, try
all the codes for your brand. If the codes do
not work, or your brand is not listed, try the
Code Search method.
7. Enter your code here for easy reference.
CODE LIST
CODE
SEARCH
INDICATOR
LIGHT
DVD
(BLINK)
1
2
3
4
5
6
(OFF)
7
8
9
0
ON•OFF
DVD CODE
7