Kohler K-T12007 Guia De Instalacion página 4

Slip-Fit Spouts
Copper Tube
Apply plumbers
putty.
1-1/2" (3.8 cm) –
2-7/8" (7.3 cm)
Setscrew
5/32" Hex Wrench
1. Install the Spout
CAUTION: Risk of internal seal damage. Do not use
petroleum-based lubricants when installing slip-fit spouts. If the
spout will not slide over the tubing, use soapy water or a
silicone-based lubricant.
CAUTION: Risk of internal seal damage. Loosen the spout
setscrew with a 5/32" hex wrench prior to installing the spout.
Slip-Fit Spouts
Remove the temporary nipple from the bath elbow.
Apply thread sealant and install a 1/2" copper tube so it extends
1-1/2" (3.8 cm) to 2-7/8" (7.3 cm) beyond the finished wall.
Smooth the edge of the copper tubing.
Loosen the setscrew with a 5/32" hex wrench.
Apply a bead of plumbers putty or other sealant around the inlet
end of the spout according to the manufacturer's instructions.
Install the spout and carefully retighten the setscrew. Do not
overtighten the setscrew.
Remove all excess putty.
Threaded Spouts
Remove the temporary nipple from the bath elbow.
1031258-2-B
Threaded Spouts
Nipple
3-7/8"
(9.8 cm)
Apply plumbers
putty.
4 Kohler Co.