Publicidad
Idiomas disponibles
Idiomas disponibles
®
VP FOR KIOSK
1.
Unplug Kiosk power cord before removing cover.
2.
Remove (4) allen head screws and lower cover.
3.
Attach (2) stud mount fasteners to the
back of the VP Server.
4.
Lift and rotate VP Server into position
on Kiosk bridge, then secure.
5.
Attach power cord.
NOTE: Power cord has "flag" connector.
Do not confuse with media:scape
switcher power cord.
6.
Attach HDMI cable one to one (refer to page 5).
7.
Attach network ethernet cable.
8.
Enable input lag reduction setting
(recommended, see page 6).
9.
Reinstall the cover.
10.
Plug the unit back in.
NOTE:
The Kiosk mains plug will be considered the
disconnect device for both the Kiosk and the
virtual puck; the disconnect device shall remain
readily operable to the user.
WARNING: To reduce the risk of fire or electric
shock, do not expose this apparatus to rain or moisture.
1
2
3
TIP: Rotate VP SERVER
into place using keyhole slots.
2329140 Rev G
Page 12 of 13
Publicidad
