Publicidad
Idiomas disponibles
Idiomas disponibles
®
DIGITAL SWITCHER CONFIGURATION
Configuration for media:scape can be accomplished using OSD. To enter configuration mode, press and hold
power button for approximately 5 seconds. After that OSD will display the current status of the switcher. In
this mode, only
PUCK 1 will light up. To enter configuration mode
user needs to enter
password:
1342. The
PUCK will flash and
unit will be ready for configuration.
total of 15 fields can be changed
either through the OSD or TCP/UDP format. Keys 1 and 3 are used to move between fields Keys 2 and 4 are
used to change setting value for that
.
If
standard cabling shown on PAGE 5, change the setting values to the following:
OUT1 AUX OVR: 1
OUT2 AUX OVR: 2
If V
P
+ HDVC cabling
shown on
PAGE 6, change the setting values to the following:
OUT1 AUX OVR: 2
1
OUT2 AUX OVR: 3
WALK-UP: 7 (only if new wux listed below,
if original do not change walk-up setting)
2
NEW WUX
Page
of 1
ORIGINAL WUX
2329140 Rev G
Publicidad
