DCU Tecnologic 3743243000P Manual De Instrucciones página 12

FUNCTIONING
• Check 12V or 24V DC input voltage and the 220V AC inverter output. Never connect a 12V device to
a 24V battery.
• The units with nominal power of 300 watts can be connected to the cigar lighter socket of the vehi-
cle (built-in accessory).
• More 300 watt power equipment can NOT be connected to the cigarette lighter socket of the vehicle.
Red (+)
• In equipment with more than 300 Watts, connect the RED terminal of the inverter to the + terminal
of the battery and connect the BLACK terminal of the inverter to the terminal - of the battery.
• Insert the plug of your device into the AC socket on the plug on the front of the inverter.
• Turn on the power switch on the front of the inverter, and the green LED will light up as an indicator
that the unit is working.
CAUTION: Do not power more than 300 Watts with the inverter if it is connected to the car cigarette
lighter socket. Doing so could melt your car's fuse and damage the vehicle's electrical installation.
RECOMMENDATION: If the inverter beeps, turn off the equipment, disconnect all inverter devices and
disconnect the inverter from the battery. The beep is simply the low battery warning, which indicates
that the battery voltage is decreasing. Please restart the vehicle's engine or charge the battery before
restarting the inverter.
Notes:
- The alarm may sound when the inverter shuts down. This same alarm can also sound when the inverter is connecting or
disconnecting from the battery bank.
- When you are not using the inverter, turn off the switch, this will prevent the consumption of stand-by.
- Disconnect the inverter when the vehicle engine starts.
Black (-)
ENG 12
Inverter DC/AC