Solve Problems - DCU Tecnologic 3743243000P Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BATTERY USE
• To prevent excessive discharge of your vehicle's battery, we recommend operating the inverter with
the engine running.
• If you connect the equipment directly to the battery terminals, it is important that you connect with
the correct polarity (Connect the inverter's RED to the + battery terminal and connect the inverter's
BLACK to - the battery's terminal), otherwise the equipment will be damaged.
• Never operate the inverter and the battery in, or near water.
SAFETY CAUTIONS DCU
• This equipment must be installed by qualified personnel, in case of error in the connection, the
equipment may be unusable.
• Do not open the inverter housing. The high voltage inside the unit is the same type of power as our
electrical outlets in the home.
• Do not allow the cable of the inverter or the cable of any device to get wet.
• Do not operate the inverter in or near water. The voltage of the unit creates a risk of electric shock if
operated in humid conditions.
• Do not connect the inverter directly to another AC power source through the power outlet plugs of
the equipment.
• Make at least 5cm of free space around the inverter for proper ventilation.
• If you install the inverter in a vehicle, you must fix the equipment well to prevent it from moving
while the vehicle is moving.
• If you detect any problem with the inverter, disconnect all power.

SOLVE PROBLEMS

TROUBLE/INDICATION
No AC output-the Red LED is ON
Shut down after operating
for a long time
Shut down after operating
short time, inverter is cold
MAINTENANCE
Very little maintenance is required for the inverter to function properly, just keep the passenger com-
partment clean, dry and well ventilated.
POSSIBLE CAUSE
DC input below 10 Volts(DC12V Model)
or 20 volts (DC24V Model). Excessive load
Over-temperature
Over-Load
ENG
Inverter DC/AC
SUGGESTED REMEDY
Recharge or replace battery
Disconnect the inverter and put
aside for while to cool down the unit.
Reduce the wattage
of the inverter's load
13
Reducing load

Publicidad

Tabla de contenido
loading

Tabla de contenido