KNOTT KS25 Instrucciones De Montaje Y Servicio página 42

Cleaning the coupling head
Clean any large pieces of dirt off the coupling head and check for damage or
heavy corrosion.
The coupling head must be smooth-running and close and lock automatically on
a dia. 50 ball. It must be replaced if it is permanently stiff or if there is damage,
pronounced wear or heavy corrosion.
10.3 Replacing friction elements
The friction elements can be replaced in case of wear or contact with oil or grease.
The spare parts kit 209698.001 contains 2 friction elements for replacing the front
and rear friction elements.
Use only original KNOTT friction elements.
These are an exact match for the KS30 / KS35 stabilising coupling head.
Using third-party linings can result in either no stabilising effect or the
ball neck being damaged. For the replacement itself, please refer to the
instructions enclosed with the kit.
version 5.00/2021 . 209692.002
18