Torque Setting; Operation; Mode Of Operation - Meister i-drill MAS 16ib Manual De Instrucciones

MC-5450500-Bedien-1308 02.08.13 07:52 Seite 69
8 – Torque setting
The drill screwdriver has a 25+1-stage
torque setting (2) in order to avoid damage
to the bolt or drilling heads. By rotating the
head on your drill screwdriver, you can
adjust the stage necessary in each case,
from 1 (easily turned screw) to max.
(stiff screw-driving/drilling
select the torque most favourable for the
respective work.
9 – Operation
All standard screwdriver bits, bit holders
and drills, up to a diameter of 10 mm
(not in the scope of delivery), can be
clamped in the drill chuck (1) (Fig. 5).
The machine is provided with a quick-
action drill chuck. In this way, you can
replace the accessories in manual
operation rapidly and without drill chuck
keys (Fig. 6).
The drill chuck of clockwise/
anti-clockwise rotation machines
is always fixed with a left-hand thread
bolt. This is to be loosened in front
through the drill chuck (1) before a
drill chuck change. Left-hand thread
bolts can be loosened through
clockwise rotation only.
Screwdriver drill bits with a length
upwards of 50 mm can also be inserted
directly into the chuck.
Starting and stopping
• Starting: Press the ON/OFF switch (3):
The screwing process will start. Press
and keep the switch during the screwing
process.
• Stopping: As soon as the screw has
been screwed in or removed fully,
All manuals and user guides at all-guides.com
LED working light (9)
). Always
make working in dark areas more safe.
The working light goes out when the
On/Off switch is released.
laser as this may result in damage to
the eyes.
Rechargeable battery charge
display (10)
To check the charge status of the
battery pack, press the test button (14) .
The battery pack charge display (10)
lights up briefly either in full or partially
to indicate the charging status as
follows:
• If the entire display area lights up:
• If half of the display area lights up:
• If a third of the display area lights up:
• If a third of the display area flashes:
10 – Mode of operation
Electronic rotation speed regulation
Using the electronic rotation speed
regulation (3), you can adapt the rotation
speed continuously to the respective job.
release the On/Off switch. The
process is completed and the working
light will go out.
When the unit is switched on, the
LED working light also comes on
to ensure better vision and to
CAUTION! LED is laser class 1!
Do not look directly into the
The battery is fully charged.
The battery is only half charged.
A third of the battery is charged.
The battery must be charged.
69