BGS technic 9451 Manual De Instrucciones página 2

ATTENTION
Read the assembly instructions carefully before
using the product.
ASSEMBLY INSTRUCTIONS
Insert the hooks with thumb force.
The clamp must be easy to rotate, after inserting in the clamp guide of
the axle boot.
After inserting, the pressing range must be approx. 8 mm for the pliers.
Cut the projecting end of the clamp with a nipper pliers.
INCORRECT ASSEMBLY
If the clamp is attached as shown in the figure, there is no sufficient
press range of 8 mm remained for pressing the clamp bridge and the
clamping on the axle boot is not achieved in the required manner.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Axle Boot Clamp Set, 12 pcs.
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 9451
9452
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed