Using The Smart Scale - Etekcity ESF-551 Manual Del Usuario

EN

Using the Smart Scale

Note:
• To switch between kilograms (kg), stone (st), and pounds (lb), open the
VeSync app and select the weight unit in the Device Settings menu. To
see measurements besides weight, you must connect the scale to the
VeSync app (see page 19).
• Turning on Zero-Current Mode in the VeSync app will turn off the scale's
electrical current and will only provide measurements for weight and
BMI. This mode can be helpful for users who are pregnant or who have
implanted medical devices, such as pacemakers.
• To measure your baby or pet, turn on Baby Mode and follow the in-
app instructions for weighing. Baby Mode will not measure other body
metrics and will only measure weight and BMI.
1. Place the scale on a hard, flat surface.
Note:
• Placing on soft surfaces such as a shaggy carpet may cause inaccurate
measurements or tipping. If necessary, the scale can be used on low-pile
carpet with a fiber length of 10 mm / 0.4 inches or less.
2. Step on the scale, then step off. Wait for the LED screen to
display "0.00" before using.
3. Place dry, bare feet on the scale's conductive areas. Stand on
the scale until the display flashes several times, showing your
final measurement. If your smart scale is connected to the
VeSync app, additional results (such as BMI, body fat, etc.) will
show in the app.
21