Marshall MOTIF A.N.C. Manual Del Usuario página 2

ENGLISH
GETTING STARTED
1. Open the charging case.
2. Press and hold the button on the case until the LED turns to a slow blue pulse.
3. Select MOTIF A N C from your sound device's Bluetooth
4. Download the Marshall Bluetooth app and follow the in-app instructions
to complete the setup.
TOUCH CONTROLS
Touch the left or right earbud to control your music, phone calls and more. The
long touch behaviour can be customised in the app.
• 1 touch to play/pause or receive/end a call
• 2 touches to skip forward or reject a call
• 3 touches to skip backward
• Long touch to toggle noise cancelling, transparency and ANC off
CHARGING THE EARBUDS
Put your earbuds back in the case and close the lid to turn them off and begin charging.
S / M / L
CHARGING THE CASE
Use a wireless charger or plug the case into a USB power source to charge it. The
case is fully charged when the front-facing LED is steady green.
To charge the case using a wireless charger, follow the instructions below.
1. Place the charging case with its back flat against the wireless charging pad.
2. Make sure that the front LED lights up to indicate that the case is charging.
3. Once the LED light has turned steady green the case is fully charged.
LED INDICATOR
The LED shows the case battery charge, from red through yellow to green
(0–100%). It pulses blue while in Bluetooth pairing mode.
NOISE CONTROL
Long touch either earbud to cycle through the noise control modes.
• Noise cancelling mode - blocks out your surroundings and lets you focus on
the music
• Transparency mode - allows you to hear your surroundings and hold
conversations without removing your earbuds
list.
®
• Off – noise control is turned off
The amount of noise cancelling and transparency can be adjusted in the Marshall
Bluetooth app.
PAIRING A NEW DEVICE
Motif A.N.C. remembers up to 3 previously paired devices and will try to
reconnect with the last connected device.
1. Place the earbuds in the case and keep the lid open.
2. Press and hold the button on the case until the LED turns to a slow blue pulse.
3. Select MOTIF A N C from your sound device's Bluetooth list.
Note: Motif A.N.C. can be connected with one sound device at a time. Make sure to
disconnect from the current device before reconnecting with a different device.
RESETTING THE EARBUDS
If your earbuds become erratic or unresponsive, follow the instructions below.
1. Place the earbuds in the case and close the lid to restart the earbuds.
If the problem persists, perform a hardware reset:
1. Place the earbuds in the case and keep the lid open.
2. Press and hold the touch surface on both earbuds for 4 seconds to reset the earbuds.
If the problem persists, perform a factory reset.
Note: This will delete all user settings and the earbuds will need to be set up again.
1. Place the earbuds in the case and keep the lid open.
2. Press and hold the the button on the case for 10 seconds, until the LED turns
purple, to reset the earbuds to factory settings.
3. Remove MOTIF A N C from your sound device's Bluetooth list before pairing again.
003