G50029; Assembling; Operating; Oscillation - TREVIDEA g3ferrari MAESTRO Instrucciones De Uso

- Before each use, unroll the power cord. Do not insert anything through the protection grids.
- Do not obstruct in any way the protection grids.
- Place on solid and stable surfaces and away from windows or drafts.
DESCRIPTION G50029
1 Front protection grid
4 Rear fan stopper
7 Oscillation pin
10 Control panel
13 Power cord
15 Motor protection

ASSEMBLING

The fan motor can work even if the protective grids have not yet been assembled and fixed.
To ensure the maximum safety, perform the installation completely before operating.
1) Insert the base (14) in the detachable base (11), as shown in the figure.
2) Joint the appropriate clips and stop the two sides with the supplied screws (12).
3) Place the rear grid (5) near the plastic motor protection (15) with the metal handle facing
upwards. Fit the holes present in the central part of the grid with the pins in the plastic protection (15) and
lock the two parts with the stopper (4).
4) Insert the fan (3) into the shaft (6) and screw the cover of the fan (2) to the threaded end of the drive shaft.
Remove the fixing screw (16).
5) Place the front grid (1) in front of the rear grid (5) matching the holes on the grids. Close the locking pins
and fasten the two grids tightening the securing screw (16) previously removed.
The fan installation is now complete.

OPERATING

Once finished assembling the unit, place the fan following the safety instructions, then plug it to the electrical
outlet. By using control panel (10) the rotation power can be adjusted on different speeds.
- 0: fan is OFF
- 1: low speed
- 2: medium speed
- 3: high speed

OSCILLATION

The oscillation of the head is only possible when the fan is turned on and it can be activated by pressing the
pin (7) downwards until it locks. Lifting the pin (7) until the locking function is disabled. It is recommended
to enable or disable oscillation of the fan only when the unit is off.

CLEANING

Disconnect the plug from the electrical outlet before attempting any cleaning operation.
Do not immerse the unit in water. In any case prevent splashes of water or other liquids reaching the motor
body. Do not clean the unit with metallic sponges or abrasive cleaners, only use neutral detergents and a soft
cloth moistened with water to clean the outer parts.
Dry the product completely before operating the unit.

TECHNICAL FEATURES

•
Power supply: AC 230V
•
Fan diameter: 40cm
•
3 operation speeds - Oscillation
2 Fan stopper
5 Rear protection grid
8 Main body
11 Detachable base
14 Base
16 Front grid fixing screw
~
50Hz. Max input power 45W
3 Fan
6 Drive shaft
9 Inclination pin
12 Screws for the base
9