Operation; Insert/Replace The Blade; Switching On And Off - Parkside PGSA 4 A1 Traducción Del Manual De Instrucción Original

GB MT
• The device may only be powered with
SELV (Safety Extra Low Voltage) as
marked on the device.
• Before initial use, charge the battery
installed in the equipment. Do not
charge the battery for several short pe-
riods in succession.
• Use the charger supplied to charge the
Li-ion battery installed in the equipment.
• Recharge the battery if the equipment
runs too slowly.
• In all cases, observe the applicable safety
information as well as the regulations and
directions for environmental protection.
• Defects resulting from improper han-
dling are not subject to the guarantee.
1. Insert the safety key (7).
2. Connect the charger cable plug
(15) with the charger socket on
the tool (5).
3. Connect the power supply unit
(14) to a socket.
The charging indicator (2) lights up:
Red: Equipment charging.
Green: Charging inished.
The recommended charging time
is approx. 3 – 5 hours.
4. After the recharging process
is completed, irst unplug the
charger from the wall outlet, and
then remove the charger cable
plug (15) from the tool.

Operation

Keep to noise abatement regula-
tions and other by-laws.
64
All manuals and user guides at all-guides.com

Insert/replace the blade

Before inserting or replacing
the blades, make sure that
the appliance is switched
off and the safety key (7) is
pulled in order to prevent
hazards and injuries.
Insert the blade
1. Put the grass cutting blade (10) or
the bush cutting blade (12) onto
the plug-in connector (16) on the
bottom side of the cutter head (1).
2. Press the blade into the direction
of the cutter head (1). It locks into
place audibly.
Remove the blade:
3. Press the release buttons (9) on
the cutter head (1) and remove
the entire blade.

Switching on and off

1. Remove the blade guard (11/13)
before switching the unit on.
2. Insert the safety key (7) into the
device.
3. To switch on, hold the switch lock
(3) depressed and operate the
on/off switch (8). Then release
the switch lock.
The equipment runs at top speed.
4. In order to switch off, let go of
the on/off switch (8).
After switching the unit off, the
blades take a short time to stop
moving. Let the blades come
to a complete standstill. Do not
touch the blades or slow them
down before the moving parts
have come to a standstill.