Eiko SEN5A/PIR/Z10 Manual Del Usuario página 6

DAYLIGHT SENSOR FUNCTION:
ALWAYS TURN OFF THE POWER SUPPLY FROM MAIN CIRCUIT BREAKER FIRST!
• OPEN THE DAYLIGHT SENSOR BY PUSH
• THE LIGHT SWI TCHES
ON AT 100% WHEN
THERE IS MOVEMENT
DETECTED.
• WHEN THE NATURAL
LIGHT LEVEL EXCEEDS
SETPOINT OFF TO
LIGHT. THE LIGHT
WILL TURN OFF EVEN
IF WHEN THE SPACE
IS OCCUPIED.
CORRIDOR FUNCTION VS DAYLIGHT SENSOR FUNCTION:
• IN THE CORRIDOR FUNCTION, TO ACTIVATE THE LIGHT THE NATURAL LIGHT LEVEL MUST BE LOWER THAN THE
DAYLIGHT SENSOR SETTING AND OCCUPANCY. WITH THE SMART DAYLIGHT SENSOR FUNCTION, THE NATURAL
LIGHT LEVEL MUST BE LOWER THAN THE DAY LIGHT SETPOINT TO ACTIVATE THE LIGHT EVEN IF THERE IS
VACANCY.
• IN THE CORRIDOR FUNCTION, TURN OFF THE LIGHT USING STAND-BY TIME END WITH VACANCY. TO TURN OFF
THE LIGHT WITH THE SMART DAYLIGHT SENSOR FUNCTION, THE NATURAL LIGHT LEVEL MUST BE HIGHER THAN
THE DAYLIGHT SETPOINT TO EVEN IF THERE IS OCCUPANCY.
• IN THE SMART DAYLIGHT SENSOR FUNCTION, NATURAL LIGHT LEVEL MUST BE HIGHER OR LOWER THAN THE
DAYLIGHT SETPOINT TO TURN THE LIGHT ON OR OFF. THESE PARAMETERS MUST BE KEPT FOR AT LEAST 1
MINUTE TO TURN THE LIGHT ON OR OFF AUTOMATICALLY.
EiKO Global | 23220 W 84th St, Shawnee, KS 66227 | (P) 1-800-852-2217
EiKO Canada | 81 King St, Barrie, Ontario L4N 6B5 | (P) 1-705-721-5189
WHEN REMOTE CONTROL IS IN SETTING CONDITION.
• THE LIGHT DIMS TO
STAND-BY LEVEL
AFTER THE HOLD-
TIME.
• THE LIGHT
AUTOMATICALLY
TURNS ON AT
10% WHEN
NATURAL LIGHT IS
INSUFFCIENT (NO
MOTION).
• THE LIGHT REMAINS
IN DIMMING LEVEL AT
NIGHT.
OFF
• SETTINGS:
• HOLD-TIME: 30 MIN
• SETPOINT ON: 50LUX
• SETPOINTOFF:300LUX
• STAND-BY DIM: 10%
• STAND-BY PERIOD: +∞
(WHEN THE SMART
PHOLOCELL SENSOR
OPEN, THE SLAND-BY
TIME IS ONLY +∞)
ON
CHECK
EVERY 30
MIN
DIM
NO MOTION
MOTION
END OF
HOLD
TIME
ON
eiko.com