Additional Safety Information - Craftsman CMCST910 Manual De Instrucciones

the danger. To reduce the risk of rebound (ricochet) injury,
work going away from any nearby solid object such as wall,
steps, large stone, tree, etc.
USE GREAT CARE when working close to solid objects and
•
where necessary, do trimming by hand.
DAMAGE TO UNIT – If you strike or become entangled
•
with a foreign object, stop appliance immediately, remove
battery, check for damage and have any damage repaired
before further operation is attempted. Do not operate with
a broken hub or spool.
DO NOT OPERATE portable electric appliances in gaseous
•
or explosive atmospheres. Motors in these appliances
normally spark, and the sparks might ignite fumes.
STAY ALERT – Do not operate this unit when you are tired,
•
ill, or under the influence of alcohol, drugs, or medication.
DO NOT immerse appliance in water or squirt it with
•
a hose.
DO NOT allow any liquid to get inside it. If appliance does
•
get wet, allow to dry for a minimum of 48 hours.
DO NOT clean with a pressure washer.
•
DO NOT store the appliance on or adjacent to fertilizers
•
or chemicals.
• DO NOT charge appliance in rain, or in wet locations.
STORE IDLE APPLIANCES INDOORS – When not in use,
•
appliances should be stored indoors in a dry, locked‑up
place out of reach of children.

Additional Safety Information


WARNING:
tool or any part of it. Damage or personal injury
could result.

WARNING:
Everyday eyeglasses are NOT safety glasses. Also use
face or dust mask if operation is dusty. ALWAYS WEAR
CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.

WARNING:
known to State of California to cause cancer, birth
defects or other reproductive harm. Some examples of
these chemicals are:
• compounds in fertilizers,
• compounds in insecticides, herbicides
and pesticides,
• arsenic and chromium from chemically
treated lumber.
To reduce your exposure to these chemicals, wear
approved safety equipment such as dust masks that
are specially designed to filter out microscopic particles.
Never modify the power
ALWAYS use safety glasses.
Some dust contains chemicals

WARNING:
and/or disperse dust, which may cause serious
and permanent respiratory or other injury. Always
use NIOSH/OSHA approved respiratory protection
appropriate for the dust exposure. Direct particles away
from face and body.

WARNING:
personal hearing protection that conforms
to ANSI S12.6 (S3.19) during use. Under some
conditions and duration of use, noise from this product
may contribute to hearing loss.

CAUTION:
its side on a stable surface where it will not cause
a tripping or falling hazard. Some tools with a
large battery pack will stand upright but may be easily
knocked over.
Air vents often cover moving parts and should be
•
avoided. Loose clothes, jewelry or long hair can be caught
in moving parts.
The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
Wh ...................... watt hours
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
procedures outlined. When ordering replacement battery
packs, be sure to include the catalog number and voltage.
READ ALL INSTRUCTIONS
English
Use of this tool can generate
Always wear proper
When not in use, place tool on
Ah ....................... amp hours
or AC ........... alternating current
or AC/DC .... alternating or direct
current
...................... Class II Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye protection
..................... wear hearing
protection
..................... read all
documentation
7