Preparing The Bair Paws Model 875 Warming Unit For Use; Placing The Warming Unit On The Wall-Mount Bracket - Bair Paws 875 Manual Del Operador

Unidad de calentamiento
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 79
Preparing the Bair Paws
Model 875 Warming Unit for Use
Before you begin using the warming unit, make sure that it is safely placed on a flat, hard
surface such as a table, or securely mounted on a wall, IV pole, or bedrail�
Caution: Do not place the warming unit on a soft or uneven surface, such as a bed; this
may cause the air intake to become blocked, compromising the unit's performance�
A wall-mount bracket is shipped with every warming unit; the brackets for mounting the
warming unit to an IV pole or a bedrail are available separately� Please contact your local
sales representative or call Arizant Healthcare Customer Service at 1-800-733-7775 for more
information about ordering mounting brackets�
The following instructions for mounting the warming unit assume that the brackets have
already been attached to the wall or to the warming unit�

Placing the Warming Unit on the Wall-mount Bracket

1�
Snap the warming unit into position by sliding the clip on the back of the warming
unit into the groove of the wall-mount bracket� The assembly will click when the clip is
fully seated in the wall-mount bracket�
2�
Lift the warming unit straight up to remove it from the wall-mount bracket�
Note: It may be necessary to gently strike the case bottom in an upward fashion with
the palm of your hand to release the clip from the wall-mount bracket�
4
Case bottom
Wall-mount
bracket
Bair Paws® Model 875 Warming Unit Operator's Manual

Publicidad

Tabla de contenido
loading

Tabla de contenido