BGS technic 9701 Manual De Instrucciones página 4

OPERATING
1. Park the vehicle on a level surface.
2. Ensure the transmission of the vehicle is in "neutral" or "park" position and apply the parking brake.
3. Start the engine. Allow the engine to idle until it reached normal working temperature. Turn the
engine off while it's done.
4. Choose suitable suction tube from the selection and insert it through dip stick tube until reaching
the bottom of oil pan (fig.1). Note: Do not bend the suction tube during the inserting procedure.
5. Connect suction tube to the suction hose of the fluid extractor (fig. 2).
6. Raise the pump handle on top of the cover until it reaches its highest limit. Begin the pumping
process by steadily moving the pump handle up and down (fig.3). The unit will begin to extract oil
from the engine crankcase. Note: When oil in the tank reach max level the vacuum will release to
prevent overflowing.
7. Pull the suction hose out of the dipstick tube after all the oil has been sucked out. Add new oil to
the engine. Run the engine briefly to distribute the new oil in the engine. Stop the engine and
check the oil level, add oil if necessary.
Fig. 1
DRAINING
1. Remove the closure (2) from spout.
2. Pour the liquid through the pouring spout into a suitable container.
Note: After pouring if the unit can't create suction for the new operation, pull out the red rubber plug
on the backside of the handle to release the pressure..
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Fig. 2
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Fig. 3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed