Alarm Function; Using The Panic Alarm; Restore Factory Settings; Changing The Batteries - Crivit H14347 Instrucciones De Utilización Y De Seguridad

All manuals and user guides at all-guides.com
Using the stopwatch with the
pedometer (the device must be in
count mode):
j
P ress the FUNC button
into stopwatch mode. The word Stop-
watch will light up in the LC display.
28
j
P ress the MODE button
stopwatch.
j
P ress the FUNC button
count mode. The pedometer is active.
The stopwatch continues running in the
background.
j
P ress the FUNC button
return to stopwatch mode.
j
P ress the MODE button
the stopwatch.
j
P ress the CLEAR button
watch to 0.
Note: The stopwatch can only be set to
0 in stopwatch mode.
j
P ress the FUNC button
count mode.

Alarm function

Q
j
S et the required alarm time (see "Setting
parameters").
Note: The set alarm is activated every
day. The alarm signal rings for approx.
1 minute.
j
P ress the FUNC
6
MODE button
3
signal.

Using the panic alarm

Q
j
T he alarm is triggered when the panic
alarm plug is pulled out of the device.
1
3 times to get
6
to start the
3
to switch to
6
3 times to
6
again to stop
3
to set the stop-
5
to return to
6
, CLEAR , SET
5 2
to deactivate the audible
j
P ull out the panic alarm plug
wrist strap to trigger the panic alarm.
j
I nsert the panic alarm plug
the device to switch off the panic alarm.
Note: Four new LR44 batteries will sound
the panic alarm for about five minutes. We
recommend that you test the panic alarm
briefly when you wish to use the pedometer.
Replace the four LR44 batteries without delay
if the low battery state indicator

restore factory settings

Q
j
I f the equipment is exposed to a strong
electro-magnetic high-frequency field, or
if there is electro-static discharge, this may
lead to malfunctions. If malfunctions do
occur, for example the buttons do not
reach or the display is shown incorrectly,
press the RESET button
equipment to the factory defaults. Use a
thin, pointed object to do this. The mal-
functions should then be eliminated.
IMPOrtANt! Please note that this will
delete all data. It will then be necessary
to reset all the parameters.

changing the batteries

Q
or The device takes two different battery types.
Note: You should replace the smaller batteries
(type LR44) immediately when the low battery
state indicator
15
batteries (type LR44) become exhausted or
low in charge, then the panic alarm and
pedometer functions cannot be used. Do not
use the pedometer without the larger battery
(CR2032) in place or with a discharged larger
battery (CR2032). The data storage function
Getting started
on the
1
back into
1
illuminates.
15
to reset the
12
illuminates. If the smaller
GB/MT 47