TFA Sousmatic 14.1551 Serie Instrucciones De Uso página 12

Ÿ The instrument turns on and the circular symbol appears in the middle of the display. The cooking process begins.
Ÿ After the cooking is finished, an alarm sounds and the stop symbol appears. The device will turn off the heater
automatically.
Cooking time programming (with timer delay)
Ÿ Press and hold the SET button for two seconds. The timer and the clock symbols appear.
The thermometer symbol and 70,0°C (default) flash. Press the – or + button to set the desired target
Ÿ
temperature.
Ÿ Press the START/STOP button to confirm.
The clock symbol and 0:05 min. (default) flash. Press the – or + button to set the time delay for the cooking
Ÿ
process in steps of 5 minutes each.
Ÿ Press the START/STOP button to confirm.
The timer symbol and 0:05 min. (default) flash. Press the – or + button to set the desired time duration for the
Ÿ
cooking process in steps of 5 minutes each.
Ÿ Press the START/STOP button to confirm.
Ÿ Press the START/STOP button again to activate the process.
Ÿ The clock symbol and the circular symbol appear and the time display counts down the minutes.
Ÿ After time has expired, the instrument will automatically switch on and the cooking process begins.
Ÿ After the cooking process is finished, an alarm sounds and the stop symbol appears. The device will turn off the
heater automatically.
During the cooking process
Press the – or + button to check the remaining delay time/cooking time and target temperature.
Ÿ
Ÿ You can stop and restart the cooking process with the START/STOP button.
Ÿ Press and hold the START/STOP button for 2 seconds to finish the cooking process and reset all settings.
After finishing the cooking process
Ÿ Take the cooked food carefully out of the water.
Ÿ Turn off the instrument after use.
Ÿ Pull the plug out of the socket, let the instrument cool down and clean it straight after.
Care and maintenance
Ÿ Clean the device with a soft damp cloth. Do not use solvents or scouring agents. If necessary, turn the plastic cap
anticlockwise and lift the impeller protective cover to remove it.
Ÿ To assemble, place the protective cover diagonally and click it firmly. The gap on the cover must be attached to
the raised part. Replace the plastic cap and turn it to lock.
Ÿ Keep the device in a dry place.
Ÿ
Check the appliance for limescale deposits before each use.
Ÿ If necessary, descale the applinace as described under descaling.
Descaling
Ÿ Place a cooking pot on a surface and fasten the device support on the side of the pot.
Ÿ Connect the plug to a wall socket.
Ÿ Fill the pot with lukewarm tap water. The water level should be between the MIN and MAX markings.
Ÿ Apply a descaler according to manufacturer.
Ÿ Slide the red switch to the position „ON".
Press the – or + button to set 70°C as target temperature and press the START/STOP button.
Ÿ
Ÿ Switch off the instrument after 20 minutes.
Ÿ Unplug the instrument and let it cool down. Then rinse the removal parts and the immersion heater
with cold tap water.
12