Store The Machine; Troubleshooting; Technical Data - GreenWorks LMF320 Manual Del Operario

4. Take the old battery pack to recycling centre that accepts
lead acid/lithium-ion batteries. Do not discard battery
pack by burning it or in regular household trash.
5.6

STORE THE MACHINE

• Clean the machine before storage.
• Make sure the engine is not hot when you put the
machine into storage.
• Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
• Replace the damaged parts.
• Tighten the bolts.
• Speak to a person of an approved service center.
• Store the machine in a dry area.
• Make sure that children cannot come near the machine.
You must lower the handle before you put the machine into
the storage.
1. Fully loosen the handle knobs on the sides of the handle.
2. Put the upper handle down.
3. Push on each side of the lower handle.
4. Lift the sides of the lower handle around the edges of the
handle mounting brackets. Do not pinch or trap the
cables.
6

TROUBLESHOOTING

Problem Possible cause
The handle is not The bolts are not
in position. engaged correctly.
The machine does The battery ca-
not start. pacity is low.
The bail switch is
defective.
The battery key is
not put in.
The machine cuts The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does Wet grass clip-
not mulch correct- pings attach to the
ly. deck.
The mulch plug is
missing.
English
Problem
The machine is
hard to push.
There is a high vi-
bration in the ma-
chine.
The machine stops
during mowing.
Solution
Adjust the height
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
Charge the battery
pack.
* If you cannot find the solution to these problems, go to the
Replace the bail
service center.
switch.
7
Put in the battery
key.
Voltage
No load speed
ing area.
Cut width
Move the wheels
to a higher posi-
Cut height
tion.
Grass catcher capacity
Wait until the
Weight (without battery
grass dries before
pack)
mowing.
Measured sound pressure
Install the mulch
level
plug.
7
Possible cause
The grass is too
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
The blade is un-
balanced and
worn.
The motor shaft is
bent.
The blade height is
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.

TECHNICAL DATA

40 V
6000 / min
490 mm
35 - 85 mm
60 L
19,3 kg
L = 68,13 dB(A) , K = 3
PA
dB(A)
EN
Solution
Increase the blade
height.
Empty the grass
clippings from the
grass catcher.
Replace the blade.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
Increase the blade
height.
Charge the battery
pack.
Remove the bat-
tery pack and
check the deck.
Cool the machine.