In Case Of Breakdown - Cembre CP1086-W-1000-KV Manual De Uso

– Push the pump pedal downwards and block it in the low position using the support block.
– Operate the oil discharge lever until the blades on the cutting head are fully open (lack of pres-
sure).
– Disconnect the flexible insulated hose from the pump using the quick coupling.
– Clean the quick couplings and close the protection covers.
– Dry the pump and clean it with a cloth. Place the pump in its case and block it in the special
restraints to avoid it slipping.
– Dry the cutting head and the flexible insulated hose and clean it thoroughly using a cloth.
– Place the cutting head in the side compartment of the transport case.
Make sure the hose is not bent when the cutting head is placed in the case.
– Wind up the flexible insulated hose in the transport case with ample loops around the pump and
cutting head.
– Make sure this instruction manual is present in the transport case.

7. IN CASE OF BREAKDOWN

Due to unforeseen circumstances the cutting operation could not be completed or terminated as
described in section 6. In such cases special precautions must be taken, including:
– Unintentional cutting of live cable.
– Following a short circuit, contact the electricity supply utility immediately for information.
– Continue to operate the pedal of the pump until the maximum pressure valve intervenes.
– Operate the oil discharge lever for 60 seconds to make the blades return to the start position if
the damage caused by the short circuit is not too serious.
– Contact the electricity supply utility for further information.
– Access the cutting area and remove the cutting head from the cable using an insulating rod.
– Return the cable cutting unit to Cembre for test and repair (see point 8).
12