Raider RD-LM31 Manual Del Usuario página 14

14 www.raider.bg
1.28. When mowing machine always push forward. Never pull it towards your body.
1.29. Where transfer must tilt the machine when crossing zones without grass and when
transporting the machine to and from the area, which will mow, the machine must be switched off
and the cutting blade must be stopped.
1.30. Never lift or transport your lawn mower if the motor working and grass cutting blade is
rotating.
1.31. Do not tilt the machine when the motor unless it is not necessary due to the presence of
very high grass. In this case, lift the remote side of the machine by pressing the handle down and
then only as necessary. When you run the machine, hold it firmly with both hands.
1.32. When you turn the power mower for grass to watch your feet are at a safe distance from
rotating parts.
1.33. Do not use the machine when you're barefoot or in sandals. Always use a strong, closed
shoes and long trousers.
1.34. Switch off the On/Off switch and remove the plug from the mains electricity always:
when moving away from the machine;
before removal of items, which blocked the machinery;
when checking, cleaning or working on machinery;
when the machine starts to vibrate abnormally;
after coming into contact with a foreign body immediately check the machine for damage before
it benefit to removing them;
1.35. The operator or user responsible for accidents, injuries to others or the environment and
caused material damage.
1.36. Electric grass mower is designed so that all moving parts and hull ensure safe conditions
for use. For damage caused by attempts to change the structure of the electric grass mower
manufacturer is not liable.
1.37. In order to ensure safety should only use genuine parts or parts recommended by the
manufacturer.
1.38. Failure to comply with the instructions may lead to electric shock, fire and / or severe
injuries.
2. Functional description and purpose.
Electric mower is a manual with power isolation second grade. It is driven by a collector single-
phase alternating current motor and is designed for cutting grass at home. Not use the power
mower for grass operations other than its intended purpose.
3. Assembly of the components of the electric grass mower and commissioning.
Some of the mower parts are dismantled in order to reduce the volume of container during
transport.
3.1. Mounting the handle.
Place the bottom of the two tubes of the handle in the openings of the housing so that the
small transverse holes for locking screws at both ends of the tubes to coincide with the smaller
side openings in the housing. Insert locking screws into the holes and screw them. Plug the device
for holding the extension cord, the tube of the upper handle. Install the top of the handle to lower
handle with self-locking screws and nuts with handles. Attach the switch in the upper part of the
handle by means of two screws. Screw them on the inner side of the handle so that the openings
therein are aligned with holes in the housing of the On/Off switch. Attach the power cord to the
handle with clamp to hold the cable to the handle.
3.2. Assemble the plastic grass basket by joining the two parts. To this end, insert the pins
of the lower half in the corresponding holes in the upper half. Press until you hear a click. After
assembling the basket lift up the cover and attach underneath the finished basket on both hooks
at the lown mower body. Submit cover to lie on the basket. Always make sure the basket for
collecting grass clippings is well secured! If you do not need to collect the grass, it can mow
without the basket, but necessarily with cover!
3.3. Place the wheels of the front and rear axles, put washer so that you can put cotter pin into
the hole in the axle. After inserting the cotter pin in the holeр distorted both ends in opposite
directions. This will ensure the wheels.