Raider RD-LM31 Manual Del Usuario página 82

82 www.raider.bg
La tabla a continuación muestra los síntomas de falla y cómo puede ayudar, si su
cortacésped deja de funcionar normalmente. Si no puede encontrar y solucionar el problema
siguiendo las instrucciones de la tabla, comuníquese con su servicio autorizado Raider.
Atención: antes de comenzar a solucionar problemas, detenga el cortacésped y desconéctelo
Faults
Mower does not
start to work
The engine start
but the knife does
not rotate.
Engine is turned off
suddenly.
Unusual noise.
Strong vibrations.
Unequal mowing.
Engine work
hard and reduce
turnovers.
The grass remains
on the ground and
the basket (6) is not
collecting it
If necessary, repair your mower is best carried out only by qualified experts in workshops
on RAIDER, which used only original spare parts. Thus ensuring their safe operation.
7.Protection of the environment.
For the environmental protection of the power tool, the electrical appliances and
packaging must undergo appropriate processing for the re-use of the valuable raw
materials contained therein. Do not dispose of power tools in household waste!
According to EU Directive 2012/19 / EC on end-of-life electrical and electronic
devices and the validation and as a national law, power tools that can no longer
be used must be separately collected and subjected to appropriate processing for
the recovery of the contents making them valuable raw materials.
Removal
Power cable is not connected or damaged
Mower is in a tall grass.
It is possible that the mower is fuzzy and
the blade is blocked.
The power plug is withdrawn
Bolt of the blade is loose or connections
between fasteners.
Distorted and damaged knife.
The grass is very high.
The blade is blunt.
It is possible that the mower is fuzzy and
blocked
The blade can be installed incorrectly.
The grass is very moist.
Outlet is clogged
Grass baskets full
Basket grass is contaminated.
Reasons
Check cable. If necessary,
replace it.
Upon initial release always put
the mower in the grass
Disconnect the plug and
check it. Put on your
protective gloves and clean
the knife and release
Check cable. Make sure it is
well enshrined in the device
(14) and plug it again.
Fasten the parts.
Immediately stop the mower
and replace the knife in a
specialized service.
Increase mowing height.
Replace or tipped knife. See
5.2.
Look underneath the mower
and clean it. Work always with
protective gloves.
Check. See 5.2
Wait for grass areas to dry
Disconnect the plug and
clean it.
Disconnect the plug and
empty the basket
Switch off the power plug from
the mains electricity. Cleaning
the basket. Baskets should
always to be clean to allow air
to pass freely through it.