INS-864-12
Operating Instructions for Model SL-864
60 LED Corded Work Light on Retractable Reel
Multiple Patents Pending
Electrical Rating - All models use 125 Volts 60 Hz
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK AND FIRE - PULL PLUG
WHEN SERVICING THE CORD REEL.
CAUTION
DO NOT use this cord reel in explosive atmospheres, near flammable liquids, or where
explosion proof lamps are required.
DO NOT use in the proximity of vehicles or equipment when there is a risk of flammable
liquids coming into contact with the hand lamp
DO NOT immerse in water
DO NOT use in areas where water can accumulate or in rain or mist
CAUTION: Risk of Electric Shock – For Light Duty Dry Location Use Only
GENERAL USE CORD REEL ONLY. NOT FOR HARD USE. FOR INDOOR DRY
LOCATION USE ONLY FOR LIGHT DUTY RESIDENTIAL USE ONLY
WARNING: NOT FOR USE ABOVE HAZARDOUS LOCATIONS
CAUTION: DO NOT USE IN HAZARDOUS LOCATIONS AS REQUIRED BY THE
CANADIAN ELECTRICAL CODE, PART I
IMPORTANT SAFETY INSTRUCTIONS
This product has a 3 prong polarized plug on the power cord. Do not attempt to bypass
this safety feature by removing the round plug and defeat his safety feature. This plug will
fit into a grounded outlet only one way. If the plug does not fit fully into the outlet, contact
a qualified electrician. Never use with a two wire extension cord.
CAUTION: PULL OUT CORD TO FULL LENGTH WHEN USING RECEPTACLE
CAUTION: DO NOT ALLOW THE CORD TO RETRACT BY ITSELF AS DAMAGE OR
INJURY MAY OCCUR FROM EXCESSIVE REWIND SPEED
CAUTION: Drywall will not hold the weight of the reel assembly
CAUTION: Read and understand mounting instructions before attempting installation
and use of this product
Thank you for purchasing this Bayco work light. Please read these instructions before
using your work light.
OPERATION
To operate, plug into a 120 Volt 60 Hz outlet. The work light has a two position rocker
switch to activate the floodlight: or turn it off.
FEATURES
The cord is 50 ft long; 18 / 2 SVT
cord with polarized 3 prong plug.
The magnetic hook can be attached
at either the top of the light or on the
side.
The magnets can also be used to pick up small steel objects.
Adjustable cord-stop.
MOUNTING
Ceiling or Wall Installation
1. Select a location within 2 feet of an electrical outlet. The outlet for a garage door
opener is desirable.
Model
FLOODLIGHT
SL-864
60 LED • 120 Lumens
BAYCO • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • www.baycoproducts.com
2. Drywall will not hold the weight of the reel assembly, so locate a ceiling joist or wall
stud and using the mounting bracket as a template, mark the holes so they are
centered on the ceiling joist or stud.
3. Attach the mounting bracket to the stud using the 2 wood screws provided.
4. Align the holes on the side of the reel with the holes in the side of the mounting
bracket and insert the pin.
5. Place the retaining ring on the pin and twist until the entire ring is through the hole in
the pin. DO NOT operate this reel without the retaining ring in place on the pin.
SAFETY / CARE
Reel
Caution: do not allow the cord to retract by it self as damage or injury may occur from
excessive rewind speed.
Adjust the cord stop to hold the receptacle at the desired length when the cord is
retracted.
Before cleaning the reel always unplug from the power source.
Clean the outside of the cord reel only. Use a soft cloth with mild detergent. Do not
use petroleum based to clean the cord reel. Never immerse the cord reel or
receptacles or work lights in water. Dry thoroughly before attempting to reattach to
power source.
LED Work Light
CAUTION BRIGHT LED RADIATION: AVOID DIRECT EYE EXPOSURE. The light is a
Class 2 LED product per IEC 60825-1 Edition 1.2.2001.
Do not use this work light in explosive or hazardous areas.
Do not attempt to repair or disassemble the work light. There are no user replaceable
parts for this work light
WARRANTY
PRODUCTS COVERED UNDER THIS LIMITED WARRANTY:
This product is warranted to the original purchaser for 1 year and only covers failures due
to defects in materials or workmanship. If this product is used for rental purposes, the
warranty term is reduced to 90 days from the date of purchase.
NOT COVERED
The warranty does not cover normal wear and tear or cosmetic damage. The Limited
Warranty also does not cover damages which occurred in shipment or failures which
are caused by accidents, misuse, abuse, faulty installation and lightning damage.
Consequential damages, incidental damages or incidental expenses, including damage
to property. Some states do not allow the exclusion or limitation of incidental or
consequential damages, so the above limitation or exclusion may not apply to you. This
warranty gives you specific legal rights, which may vary from state to state.
This warranty does not apply to certain Bayco professional products that carry a specific
warranty unique to those products.
WARRANTY CLAIMS - USA
Contact Bayco for USA warranty claims. Call 800-233-2155 and Bayco Customer
Service will provide a Return Goods Authorization (RGA) to facilitate rapid warranty
action. After receiving the RGA, send the product (shipping prepaid) to BAYCO • 640 S.
SANDEN BLVD • WYLIE, TEXAS • 75098. Include a dated proof of purchase and a brief
description of the defect with your name, address and phone number. Your product will
either be repaired or replaced at the option of Bayco and returned as soon as practical,
but no later than 45 days after being received by Bayco.
WARRANTY CLAIMS - CANADA