Instruction Manual
THANK YOU FOR PURCHASING THE SL-866 LED WORK LIGHT ON REEL.
SAVE THESE INSTRUCTIONS.
PLEASE READ THESE INSTRUCTIONS BEFORE USING YOUR WORK LIGHT.
ELECTRICAL RATING - 125 VOLTS 60 HZ
CAUTION - TO REDUCE THE RISK OF ELECTRIC SHOCK AND FIRE - PULL
PLUG WHEN SERVICING THE CORD REEL.
CAUTION
• DO NOT use this cord reel in explosive atmospheres, near fl ammable liquids, or
where explosion proof lamps are required.
• DO NOT use in the proximity of vehicles or equipment when there is a risk of
fl ammable liquids coming into contact with the hand lamp
• DO NOT immerse in water
• DO NOT use in areas where water can accumulate or in rain or mist
• CAUTION: Risk of Electric Shock – For Light Duty Dry Location Use Only
• GENERAL USE CORD REEL ONLY. NOT FOR HARD USE. FOR INDOOR DRY
LOCATION USE ONLY FOR LIGHT DUTY RESIDENTIAL USE ONLY
GENERAL USE CORD REEL ONLY. NOT FOR HARD USE. FOR INDOOR DRY
LOCATION USE ONLY FOR LIGHT DUTY RESIDENTIAL USE ONLY
WARNING: NOT FOR USE ABOVE HAZARDOUS LOCATIONS
CAUTION: DO NOT USE IN HAZARDOUS LOCATIONS AS REQUIRED BY THE
CANADIAN ELECTRICAL CODE, PART I
IMPORTANT SAFETY INSTRUCTIONS
This product has a 3 prong polarized plug on the power cord. Do not attempt to
bypass this safety feature by removing the round plug and defeat his safety feature. This
plug will fi t into a grounded outlet only one way. If the plug does not fi t fully into the outlet,
contact a qualifi ed electrician. Never use with a two wire extension cord.
CAUTION: PULL OUT CORD TO FULL LENGTH WHEN USING RECEPTACLE
CAUTION: DO NOT ALLOW THE CORD TO RETRACT BY ITSELF AS DAMAGE
OR INJURY MAY OCCUR FROM EXCESSIVE REWIND SPEED
CAUTION: DRYWALL WILL NOT HOLD THE WEIGHT OF THE REEL ASSEMBLY
CAUTION: READ AND UNDERSTAND MOUNTING INSTRUCTIONS BEFORE
ATTEMPTING INSTALLATION AND USE OF THIS PRODUCT
OPERATION
To operate, plug into a 120 Volt 60 Hz outlet. The work light has a two position rocker
switch to activate the fl oodlight: or turn it off.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • 1-800-233-2155 • 1-469-326-9400 • www.mybayco.com
SL-864
FEATURES
• The cord is 50 ft long; 18 / 2 SVT cord with polarized 3 prong plug.
• The magnetic hook can be attached at either the top of the light or on the side.
• The magnets can also be used to pick up small steel objects.
• Adjustable cord-stop.
MOUNTING
Ceiling or Wall Installation
1. Select a location within 2 feet of an electrical outlet. The outlet for a garage door opener
is desirable.
2. Drywall will not hold the weight of the reel assembly, so locate a ceiling joist or wall stud
and using the mounting bracket as a template, mark the holes so they are centered on
the ceiling joist or stud.
3. Attach the mounting bracket to the stud using the 2 wood screws provided.
4. Align the holes on the side of the reel with the holes in the side of the mounting bracket
and insert the pin.
5. Place the retaining ring on the pin and twist until the entire ring is through the hole in the
pin. DO NOT operate this reel without the retaining ring in place on the pin.
SAFETY / CARE
Reel
• Caution: do not allow the cord to retract by it self as damage or injury may occur from
excessive rewind speed.
• Adjust the cord stop to hold the receptacle at the desired length when the cord is
retracted.
• Before cleaning the reel always unplug from the power source.
• Clean the outside of the cord reel only. Use a soft cloth with mild detergent. Do not
use petroleum based to clean the cord reel. Never immerse the cord reel or receptacles
or work lights in water. Dry thoroughly before attempting to reattach to power source.
LED Work Light
CAUTION BRIGHT LED RADIATION: AVOID DIRECT EYE EXPOSURE. The light is a
Class 2 LED product per IEC 60825-1 Edition 1.2.2001.
• Do not use this work light in explosive or hazardous areas.
• Do not attempt to repair or disassemble the work light. There are no user replaceable
parts for this work light
WARRANTY
1 YEAR WARRANTY
Bayco Products, Inc. warrants this product to be free from defects in workmanship
and materials to the original purchaser for 1 year from the date of purchase, and includes
the LEDs, housing, lenses, electronics, switches, rechargeable batteries and chargers.
Bulbs (other than LEDs) are covered for 90 days from the date of purchase.
We will repair or replace this product should we determine it to be defective. This is the
only warranty, expressed or implied, including any warranty of merchantability or fi tness for
a particular purpose.
For a complete copy of the warranty, go to www. baycoproducts.com/bayco-product-
support/warranties. Retain your receipt for proof of purchase.
INS-864-18