Adjusting The Sound - Sony SA-F11 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
Adjusting the Sound Z
You can enjoy virtual 3D sound even without rear
speakers when you use the "VES (Virtual Enhanced
Surround)" mode in the on-screen menu of the DVP-
F11.
Some Sony DVD players other than the DVP-F11 also
have the VES mode option. If you cannot hear the
sound from the subwoofer even if you select VES
mode, connect your DVD player to the AUX IN jacks of
the subwoofer.
Refer to the instructions supplied with your DVD
player for details.
TV
VIDEO
ENTER/EXECUTE
DISPLAY
+
1
Turn on your TV, DVP-F11, and the subwoofer.
2
Press DVD on the remote.
The DVD button lights up and you can control the
DVD player using the remote of the subwoofer
(see page 8).
3
Press DISPLAY on the remote.
The Control Menu display appears on the TV
screen.
4
Select "VES" by pressing the cursor buttons ( /
/ / ) on the remote, then press
EXECUTE.
1 2 ( 2 7 )
1 8 ( 3 4 )
C 0 1 : 3 2 : 5 5
VES
OFF
OFF
VES A
VES B
To select, press
5
Select "VES A" or "VES B" and press ENTER/
EXECUTE.
1/u
DVD
DVD
Cursor buttons
+
or ENTER/
DVD
, then
.
ENTER
Basic Operations
Effects of each item
OFF
Outputs 2-channel signals for stereo sound for CDs.
The 5-channel signals of Dolby Digital sound for DVDs
are mixed down into 2-channels to be output.
VES (Virtual Enhanced Surround) A
Uses 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without
using actual rear speakers. The virtual speakers are
reproduced as shown in the illustration below.
L
VES (Virtual Enhanced Surround) B
Uses 3D sound imaging to create virtual rear speakers
from the sound of the front speakers (L, R) without
using actual rear speakers. The virtual speakers are
reproduced as shown in the illustration below.
L
Notes
• You cannot select "VES" when "DOLBY DIGITAL" is set
to "DOLBY DIGITAL" in "AUDIO SETUP."
• In case that the player outputs the signal from OPTICAL
and COAXIAL, the surround effect will be heard only
when you set "MPEG" to "PCM" in "AUDIO SETUP."
• Some discs do not have rear sound. In this case, you
cannot get the 3D surround effect.
• When you select an item, the sound cuts off for a moment.
• When the playing signal does not contain the surround
component, the effects may be difficult to hear even if you
select "VES A" or "VES B."
• Set the front speakers to form an equilateral triangle with
the listening position, or the effects may be difficult to
hear even if you select "VES A" or "VES B."
• When you select "VES A" or "VES B," set the surround
settings of the connected units, such as the amplifier, to
OFF.
R
R
GB
7

Publicidad

Tabla de contenido
loading

Tabla de contenido