Putting Into Operation - Abicor Binzel CAT2 Instructivo De Servicio

6 Putting into operation

6 Putting into operation
Risk of injury due to unexpected start-up.
The following instructions must be adhered to for the entire duration of
maintenance, servicing, mounting, dismounting and repair work:
• Switch off the power supply.
• Close off the compressed air supply.
• Disconnect all electrical connections.
NOTICE
• Please take note of the following instructions:
• The system may only be installed and put into operation by authorized
6.1 Fastening the CAT2 to the robot
This chapter describes the assembly of the robot mounts CAT2 and
CAT2 HL. The process steps step 1 to step 5 refer to both robot versions.
NOTICE
• Before CAT2 (10)can be mounted, the robot (7)must be moved to the
• To fasten the CAT2 (10) to the robot (7) a robot flange is required (8). It
• To fasten the torch (1) to the CAT2 (10) a torch mount is required (2).
EN - 14
All manuals and user guides at all-guides.com
DANGER
 3 Product description on page EN-8
personnel (in Germany see TRBS 1203).
maintenance position.
must correspond to the hole pattern of the CAT2 (10) and of the
robot (7).
This mount depends on the type of torch.
CAT2