Replacing Light Bulb - Haier HVB050ABH Manual Del Usuario

All manuals and user guides at all-guides.com
HVB050ABH manual 8/29/02
4. Remove the door support bracket from the opposite
side (left side), by removing the 2 screws. (fig.3)
5. To install the bottom hinge bracket on the opposite side (left side), you will also
have to remove one screw hole plug from the left side.
6. Install the door support bracket on the opposite side (right side), place the
screw hole plug in the bottom hole.
7. Remove the light switch bracket from the bottom of the door by removing the 2
screws. (fig.4)
8. Install the light switch bracket on the opposite
side of the door (upper part), after removing the screw hole plugs.
9. Rotate the door by 180˚. This way the light switch bracket will now be on the
bottom side and the handle on the opposite side. (right side) Place the screw
hole plugs in its appropriate hole on top of the door.
10. Carefully align the bottom hinge axle hole on the door with the axle of the
lower hinge bracket. Remember to have the door level rings in place before you
place the door on its axle.
11. Install the upper hinge bracket (left side hinge bracket supplied
as an accessory) on the left side.
12. Make sure the door is aligned and then tighten the screws.

Replacing Light Bulb

1. Turn off and unplug the power cord of the wine cooler.
2. To remove the light bulb cover use a philliphead screw driver to remove the 2
screws.
3. Make sure the light bulb is cool before removing it. Replace using a light bulb
20 watts or less.
4. After the bulb is secure, install the light bulb cover and replace both the screws.
5. Turn unit on to its original setting after plugging in the power cord.
8:38 AM Page 12
(fig.3)
(door suppport bracket)
(fig.4)
English
10