marklin 39590 Manual Del Usuario página 11

Tabla de contenido

Publicidad

Setting Locomotive Parameters with the
Control Unit
1. Requirement: Setup as in diagram on page 24. Only
the locomotive to be changed can be on the track.
2. Press the "Stop" and "Go" at the same time until "99"
blinks in the display.
3. Press the "Stop" button.
4. Enter the locomotive address „80".
5. Hold the control knob in the reverse direction area.
While holding the control knob here, press the „Go"
button.
6. The headlights on the locomotive will blink slowly. If
they don't, repeat Step 2.
7. Enter the register number for the parameter to be
changed (=> List on page 26).
8. Active the change of direction.
9. The headlights will blink rapidly.
10. Enter the new value (=>List on page 26).
11. Active the change of direction.
12. The headlights will blink slowly (exception: factory
reset)
13. Enter the next parameter setting from 6 or end with 14.
14. End the process by pressing the „Stop" button. Then
press the „Go" button.
All manuals and user guides at all-guides.com
Operation with the Mobile Station /
Central Station
• Set the locomotive on the track. The locomotive auto-
• The locomotive will not communicate back to the
• Taking the locomotive out of the locomotive list:
Changing Locomotive Parameters with the
Mobile Station / Central Station
1. Select the locomotive from the locomotive list.
2. Change to the submenu "EDIT LOC".
3. Go to the submenu „VMAX" (maximum speed),
4. Enter the new value and accept it into the system.
Please note the information in the instructions for the
Mobile Station / Central Station.
The VMAX has been preset at 87% (Mobile Station) and
at 222 (Central Station) on the model in order to give
good running characteristics. Raising this value further
will not increase the speed; it will only have a negative
effect on the running characteristics.
matically registers itself in the locomotive list.
controller when:
the speed bar on the Mobile Station blinks.
the mfx symbol has a line beneath it on the Central Station.
1. Remove the locomotive from the track.
2. Delete the locomotive entry.
It is not necessary to change the address.
„ACC" (acceleration), „DEC" (brakes), or „RESET" (reset-
ting the decoder to factory default settings).
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ae 8/14 serie

Tabla de contenido