Battery And Fuse Replacement - Amrobe AM-420 Manual De Uso

BATTERY AND FUSE REPLACEMENT

X�
Warning
To avoid shock, injury, or damage to the meter, disconnect the test lead
from the measuring circuit before opening case. ONLY use the fuse with the
amperage, interrupt, voltage, and speed ratings specified.
When replacing the battery and fuse, follow the below steps:
1. Disconnect the test lead probe from measuring circuit.
2. Turn the Meter to OFF position.
3. Remove holster and the screws from the back cover, and then open the back
cover.
4. Battery replacement: Remove the battery and replace with one 9 V Alkaline
battery (6LF22, 6LR61, MN1604) or equivalent. Pay attention to the polarity
signs.
5. Fuse replacement: Replace the broken fuse F1 with rating 315 mA H 250 V
fast-fuse, ( 5×20)mm.
6. Put the back cover back, re-fasten the screw and install the holster back.
Battery: 9 V alkaline batteries (6LF22, 6LR61, MN1604) or equivalent
Fuse: 315 mA H 250 V fast-fuse, ( 5×20)mm
Fuse
11