Symbols; Safety Information - Amrobe AM-420 Manual De Uso

SYMBOLS

X
Caution! Risk of electric shock
�
Caution! Refer to the explanation in this manual
B
Alternating Current (AC)
F
Direct Current (DC)
T
The equipment is protected by double insulation or reinforced insulation
J
Earth (Ground)
N
Battery
�
Complies with European Directives
Conforms to relevant Australian Standards
)
Independently certified for U.S. and Canadian markets
Do not dispose of this product as unsorted municipal waste. Contact a
=
qualified recycler.

SAFETY INFORMATION

This meter complies with:
IEC/EN 61010-1 3rd Edition, UL61010-1 2nd Ed. and CAN/CSA C22.2 No.
61010-1-04 + CSA Update No.1: 2008 to Category II 250 Volts, Pollution degree 2
IEC/EN 61010-2-030
IEC/EN 61010-2-31 for test leads
EMC IEC/EN 61326-1
This product has been tested to the requirements of CAN/CSA-C22.2 No. 61010-1,
second edition, including Amendment 1, or a later version of the same standard
incorporating the same level of testing requirements.
Measurement Category II (CAT II) is for measurements performed on circuit
directly connected to the low voltage installation. Examples are measurements
on house hold appliances, portable tools and similar equipment.
CENELEC Directives
The instruments conform to CENELEC Low-voltage directive 2006/95/EC and
Electromagnetic compatibility directive 2004/108/EC
X�
Warning: Read Before Using
• To avoid possible electrical shock or personal injury, follow these
instructions and use the meter only as specified in this manual.
• Do not use the meter or test leads if they appear damaged, or if the meter
is not operating properly. If in doubt, have the meter serviced.
• Always use the proper function and range for measurements.
• Before rotating the function range selection switch, disconnect test probe
from circuit under test.
• Verify the meter's operation by measuring on a known source.
3