Getting Started; Insert Batteries - Explore Scientific RPW3008 Manual De Instrucciones

GETTING STARTED

INSERT BATTERIES

1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries match
upon installation.
3. Reattach the battery door.
NOTE: Replace batteries when [
when the display is dim.
Only use a compatible AC/DC Power adapter (3.6V
4
100mA). Plug the power cable to the power jack
4
and the power adapter to a suitable power outlet.
8
OUTDOOR SENSOR
The main unit can receive data from up to 3 outdoor
sensors. 1 Sensor is included with delivery.
1. Remove the battery door from the back.
2. Insert 2x AAA (LR03)/1.5V batteries. Please
ensure the polarities (+/-) of the batteries match upon
installation.
3. Select a channel, then press TX.
] displays, or
4. Reattach the battery door.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TO SEARCH FOR A SENSOR:
Press and hold [
The sensor reception icon in the outdoor sensor area
shows the status:
(sensor found).
NOTE: The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
] to initiate outdoor sensor search.
(searching for sensor) or
FLASH
-