Homewerks 7130-13-BT Manual Del Usuario página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PREPARATION (continued)
WARNING: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut
off. Either remove the fuse or turn off the circuit breaker before removing the existing bath fan or
installing the new one.
Before removing your current ventilation fan, verify the wall switch box has the required wires
necessary for this installation. These supply wires are power (black) and neutral (white), as shown in
the wiring diagram below. If you do not see both of these wires, consult a licensed electrician.
Check area above installation location to be sure that wiring can run to the planned location and that duct work
can be run and the area is sufficient for proper ventilation.
Inspect duct work and wiring before proceeding with installation.
Before installation, provide inspection and future maintenance access at a location that will not interfere with
installation work.
You may need the help of a second person to install this fan; one person on the attic side and one on the room side.
Installation may vary depending on how the previous bath fan was installed. Supplies necessary for the installation
of your bath fan are not all included; however, most are available at your local home improvement or hardware
store.
DIMENSIONS
Ceiling
Opening (L)
Opening (W)
9-1/4 in.
WIRING
All wiring must be connected for full functionality. The grille must be connected to the fan housing before
supplying power to the fan in order for the LED Touchpad Wall Switch to pair with the fan properly. Turning
on the power supply before connecting the grille to the fan housing will interfere with the pairing process.
Do not use metal wall plate with switch.
Ground wire/green
Fan
Switch
connection/black
Fan neutral/white
Homewerks.com
Ceiling
Ceiling
Opening (H)
9-1/4 in.
8-1/4 in.
Switch/red
Housing
Dimension (L)
9 in.
Green
Red
White
Black
Power/black
AC120V/60Hz
House neutral/white
5
Housing
Housing
Dimension (W)
Dimension (H)
9 in.
7-11/16 in.
ATTENTION:
The switch included with this ventilation
fan requires a dedicated neutral wire
connection. If a neutral line is not
electrician.
NOTE: This switch is intended to only
operate independently with this bath
fan. Connections to other electrical
electrical issues.
If you require assistance, please cal l
1-877-319-3757 before attempting
switch installation.

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido