Miele FRZ01 Manual Del Usuario página 11

M.-Nr. 06258813
PW 6163, PW 6243, PW 6323
The flow meter can only be installed if the "BSF-RU flow meter clean/soiled side" kit is already installed in the
machine.
PWM912, PWM514, PWM916, PWM520, PWM920
An installed and connected connector box is requisite for installing the flow meter.
During installation, the adapter must be installed as a damper between the shutoff valve and flow meter. Take note of
the arrow marked on the flow meter showing the correct direction of flow. Use the correct seals appropriate for the
pipe diameter only. In this way water can flow freely without added turbulence through the measuring area. Correct
flow measurement can only be achieved if these instructions are complied with.
A
Connect the flow meter to a 3/4" shutoff valve; see Fig. 1.
A
Connect the water intake hose or Y-piece to the flow meter; see Fig. 2.
Flow-meter connection for PW 6101, PW 6131, PW 6161, PW 6201
A
Remove the cover plate from the electrical connection on the rear of the machine; see the model-specific TSD.
A
Connect the flow-meter wiring in accordance with the "MF07" wiring diagram.
A
Reinstall the cover plate over the electrical connection on the rear of the machine.
Flow-meter connection for PW 6107, PW 6137, PW 6167, PW 6207
A
Remove the machine lid; see the model-specific TSD.
A
Punch out an appropriately sized opening for the feed-through on the upper rear panel.
A
Install the feed-through on the upper rear panel.
A
Connect the flow-meter wiring in accordance with the "PW 6107 - PW 6207 module 7" wiring diagram.
A
Reinstall the machine lid.
Flow-meter connection for PW 413, PW 418, PW 811, PW 814, PW 818
A
Remove the machine lid; see the model-specific TSD.
A
Punch out an appropriately sized opening for the feed-through on the upper rear panel.
A
Install the feed-through on the upper rear panel.
A
Connect the flow-meter wiring in accordance with the "PW 8xx/4xx MF07 - FRZ" wiring diagram.
A
Reinstall the machine lid.
Flow-meter connection for PW 6163, PW 6243, PW 6323
A
Remove the connection box lid; see the model-specific TSD.
A
Connect the flow-meter connections to the terminal strip in accordance with the wiring diagram.
A
Reinstall the connection box lid.
Flow-meter connection for PWM 912, PWM 514, PWM 916, PWM 520, PWM 920
A
See the connector box MSD for the connector box connection.
Final steps
A
Test any newly installed water-carrying components for leaks.
A
Carry out appropriate safety checks.
A
Activate the flow meter; see the "service mode" section in the model-specific TSD.
For software IDs 1000/1001 and higher, do a manual data backup; see the "service mode" section in the
model-specific TSD.
A
Run a wash cycle to make sure that water is entering the machine correctly via the flow meter.
en-US
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
11 von 27
08.12.2021