Safety Instructions - Parkside PAS 1500 LM A1 Manual Del Usuario

z Safety instructions

Safety instructions

WARNING!
RISK OF FATAL INJURY AND
ACCIDENTS FOR INFANTS AND
CHILDREN! Never leave children
unsupervised with the packaging material�
There is a danger of suffocation from the
packaging material� Children often
underestimate the dangers� Always keep
children away from the product�
This product can be used by children aged
„
8 years and over, as well as by persons
with limited physical, sensory or mental
abilities or lacking in experience and
knowledge if they have been supervised
and instructed as to the safe use of the
product and understand the resulting
hazards� Do not let children play with the
product� Cleaning and maintenance may
not be carried out by children without
proper supervision�
Do not use the product if you notice any
„
damage�
The light source contained in this luminaire
„
shall only be replaced by the manufacturer
or his service agent or a similar qualified
person�
The mains power cable
„
cannot be replaced; if the power cable is
damaged, the product must be disposed of�
Never carry the product by the mains
„
power cable�
Always route the mains power cable in
„
such a way that nobody can tread on it or
trip over it�
AVOID THE RISK OF FATAL
„
INJURY FROM ELECTRIC
SHOCK!
Always check the product for any damage
„
before connecting it to the mains power
supply� Never use the product if it has any
signs of damage�
30
GB/MT
of this product
10
Protect the mains power cable from sharp
„
edges, mechanical stress and hot surfaces�
When connecting or disconnecting the
„
cable to/from the power supply, only hold
the insulated part of the mains plug!
Always unplug the mains power cable
„
before assembling, dismantling or cleaning
the product�
Always disconnect the product from the
„
mains power supply if it is not going to be
used for an extended period (e�g� holiday)
or if you want to set it up in a different
place�
Never open up any of the electrical
„
components or insert any objects in them�
Doing so would risk fatal injury from
electric shock�
Before using the product, make sure that the
„
mains power supply voltage matches the
supply voltage required by the product
(220-240 VAC, 50 Hz)�
AVOID THE RISK OF FIRE AND
„
INJURY!
RISK OF BURNS FROM HOT
„
SURFACES! To avoid the risk of
burns, make sure that the product
is switched off and has cooled down before
you touch it� Light sources generate a large
amount of heat�
Do not cover over the product with other
„
objects� Excessive heat build-up can cause
a fire.
Do not leave the product unattended while
„
in use� Excessive heat build-up can cause a
fire.
The LED module is not dimmable�
„
Never look directly into the light source
„
(light bulb, LED, etc�)� Never look at the
light source (light bulb, LED, etc�) through
an optical instrument (e�g� magnifying
glass)�
Any protective cover that is split or cracked
„
must be replaced�
Never direct the LED light beam at reflective
„
surfaces or towards people or animals�