Publicidad
Idiomas disponibles
Idiomas disponibles
H-4795, H-4796
H-4797
WALL-MOUNT
WIRE SHELVING
(1 SHELF)
TOOLS NEEDED
Cordless Drill
(3/16" Drill Bit)
Shelf Bracket x 2
Screw x 12
1.
Mounting brackets should be spaced 1½" shorter
than the width of the shelf. Do this by measuring
from the center of one mounting bracket to the
center of the other. Drill top mounting brackets to
the wall using (2) anchors and (2) screws for each
mounting bracket. (See Figure 1)
Figure 1
PAGE 1 OF 6
1-800-295-5510
uline.com
Step Ladder
(Optional)
Shelf Support x 2
Anchor x 12
Bolt x 4
INSTRUCTIONS
Tape Measure
PARTS
Mounting Bracket x 4
Post x 2
2. Align center mounting brackets directly below the
top mounting bracket. Mount center mounting
brackets using (2) anchors and (2) screws for each
center mounting bracket. Make sure there is enough
space between the mounting bracket and center
mounting bracket for the shelf bracket to fit.
(See Figure 2)
Figure 2
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Phillips
Screwdriver
Center Mounting Bracket x 2
Shelf x 1
Mounting
Bracket
Center Mounting
Bracket
0221 IH-4795
Publicidad
Tabla de contenido
Manuales relacionados para Uline H-4795
Resumen de contenidos para Uline H-4795
- Página 1 Para Español, vea páginas 3-4. Pour le français, consulter les pages 5-6. H-4795, H-4796 1-800-295-5510 H-4797 uline.com WALL-MOUNT WIRE SHELVING (1 SHELF) TOOLS NEEDED Cordless Drill Step Ladder Phillips Tape Measure (Optional) Screwdriver (3/16" Drill Bit) PARTS Shelf Bracket x 2...
- Página 2 5. Drill bottom mounting brackets to the wall using (2) anchors and (2) screws for each mounting bracket. Use bolts to fasten posts to bottom mounting bracket. (See Figure 5) Figure 5 1-800-295-5510 uline.com PAGE 2 OF 6 0221 IH-4795...
-
Página 3: Estantería De Alambre Para Pared
H-4795, H-4796 800-295-5510 H-4797 uline.mx ESTANTERÍA DE ALAMBRE PARA PARED (1 REPISA) HERRAMIENTAS NECESARIAS Escalera Desarmador Taladro Inalámbrico Metro (Broca de 3/16") (Opcional) Phillips PARTES 2 Soportes de Repisa 2 Abrazaderas para 12 Anclajes 4 Soportes de Montaje 2 Soportes de Montaje... -
Página 4: Continuación De Instrucciones
5. Taladre orificios para 2 anclajes y 2 tornillos por cada soporte de montaje inferior, para fijarlos a la pared. Utilice pernos para fijar los postes al soporte de montaje inferior. (Vea Diagrama 5) Diagrama 5 800-295-5510 uline.mx PAGE 4 OF 6 0221 IH-4795... -
Página 5: Outils Requis
H-4795, H-4796 1-800-295-5510 H-4797 uline.ca RAYONNAGE EN FIL DE MÉTAL POUR INSTALLATION MURALE (1 TABLETTE) OUTILS REQUIS Escabeau Tournevis Perceuse sans fil Ruban à mesurer (Mèche de (optionnel) cruciforme perceuse de 3/16 po) PIÈCES Ferrure de tablette x 2 Support de tablette x 2 Ancrage x 12... - Página 6 5. Fixez les supports de fixation inférieurs au mur en utilisant deux ancrages et deux vis pour chaque support de fixation. Utilisez des boulons pour fixer les montants au support de fixation inférieur. (Voir Figure 5) Figure 5 1-800-295-5510 uline.ca PAGE 6 OF 6 0221 IH-4795...