Assembly Step - ultega DRAFTER 550 PRO Manual De Uso

ASSEMBLY STEP

Attention!
Please cut irst the cable tie on the lower left side, before using the device. Make sure that the rope has
not been damaged.
Step 1
• Attach the Front Stabilizer (50) to the main frame
with M10x52 Screw (46) and OD20xID10.5x2.0T
Flat Washer (47).
Step 2
• Remove the Pull Pin (37), 1/2"x100 Screw (36), OD22xID13x2.0T Flat Washer (33) and Nylon Cap (54)
with spanner. (see ig.1)
• Attach the Aluminum Sliding Tube (8) to the Main Frame (39) secure by 1/2"x100 Screw (36),
OD22xID13x2.0T Flat Washer (33) and Nylon Cap (54), then insert the Pull Pin (37). (see ig.2 and ig.3)
• Put the Nylon Cap Cover (55) on the Nylon Cap (54). (see ig .4).
• Remove pull pin (37),
fold Aluminum sliding
tube (8), then insert
pull pin (37).
All manuals and user guides at all-guides.com
US
1
3
6
www.ultega.net
2
4