ultega DRAFTER 550 PRO Manual De Uso página 7

ASSEMBLY STEP
Step 3
• Pull the resistance rope (45) go through pulley (inside(3))- Pic1
• Attached Rear Stabilizer (3) to the end of Aluminum Sliding Tube (8) secure by lock with the M8x20
Screw (14) and OD20xID8.5x1.5T Flat Washer (16)
• Pull the resistance rope under Aluminum sliding Tube (8), then hook on holder- Pic 4
• Loosen Knob (87), Flat Washer (88), move Pull Pin (37) to make aluminum sliding on the loor, then
Screw Knob (87) with Flat Washer (8), insert the Pull Pin (37).
1
4
All manuals and user guides at all-guides.com
US
2
7
www.ultega.net
3