Kunft KDH4756 Manual De Instrucciones página 14

• Insert the water hose into the unit from the drain outlet in the back
of the unit as shown in Fig.8.
• Attach the water hose to the drain hose outlet of the unit.
• Make sure the connection of the water hose and the drain hose
outlet of the unit is tight and does not leak water.
• Lead the water hose to the floor drain or a suitable drainage facility.
The drainage facility should be lower than the drain outlet of the
unit. Be sure to run the water hose sloping downward and let the
water flow out smoothly. Do not install the water hose as shown
Fig.9a and Fig.9b.
• Make sure the water hose is lower than the drain hose outlet
Do not block water
flow by rising the
Remove
the rubber
plug
Insert
the water
hose from
the drain
outlet
Fig. 8
NOTE: when the continuous drain feature is not being used, remove
the drain hose from the outlet and reinstall the rubber plug.
26
Do not block water
flow by bending the
hose.
hose.
Fig. 9a Fig. 9b
dehumidifier
2.3. Maintenance
Turn the dehumidifier off and remove the plug from the wall
outlet before cleaning it.
1. Clean the Grille and Case
• Use water and a mild detergent. Do not use bleach or abrasives.
• Do not splash water directly onto the main unit. Doing so may cause
an electrical shock, cause the insulation to deteriorate, or cause the
unit to rust.
• The air intake and outlet grilles get soiled easily, so use a vacuum
attachment or brush to clean.
2. Clean the collector
• Every few weeks, clean the collector to prevent growth of mold,
mildew and bacteria. Partially fill the collector with clean water and
add a little mild detergent. Swish it around in the collector, empty it
and rinse it.
NOTE: do not use a dishwasher to clean the collector. After cleaning
it, the collector must be in place and securely seated for the
dehumidifier to operate.
3. Clean the air filter
The air filter behind the front grille should be checked and cleaned at
least every two weeks or more often if necessary.
NOTE: DO NOT RINSE OR PUT THE FILTER IN A DISHWASHER.
To remove:
• Pull the water collector as shown in Fig. 10a.
• Grip the tab on the filter and press it in slightly to take it out from the
filter holder, then pull out the filter downward (see Fig.10b).
• Clean the filter with warm, soapy water. Rinse and let the filter dry
before replacing it. Do not clean the filter in a dishwasher.
Fig. 10a
To attach:
• Insert the filter into the unit, then press the tab on the filter slightly
and push the filter upward for model A.
• Insert the right and left filters into the unit for model B.
• Then reinstall the water collector properly.
EN
KDH4756
Grip the tab
on the filter
and press
them in.
Pull out
the filter
downward.
Fig. 10b
27