Kunft KDH4756 Manual De Instrucciones página 15

NOTE: when re-install the filter, please pat the middle buckles of the
filter first and then pat the bottom buckle.
CAUTION:
DO NOT operate the dehumidifier without a filter because dirt and lint
will clog it and reduce its performance.
NOTE: The cabinet and front may be dusted with an oil-free cloth or
washed with a cloth dampened in a solution of warm water and mild
liquid dishwashing detergent. Rinse thoroughly and wipe dry. Never
use harsh cleansers, wax or polish on the cabinet front. Be sure to
wring excess water from the cloth before wiping around the controls.
Excess water in or around the controls may cause damage to the unit
4. When not using the unit for long time periods
• After turning off the unit, wait one day before emptying the collector.
• Clean the main unit, water collector and air filter.
• Wrap the cord and bundle it with the band (see Fig.12).
• Cover the unit with a plastic bag.
• Store the unit upright in a dry, well-ventilated place
NOTE: you should loosen the screw on the cover of the collector
before cleaning it and then re-installing it.
Band
Cord
28
dehumidifier
2.4. Troubleshooting
Before calling for service, review the chart below first yourself.
Problem What to check
The unit does • Make sure the dehumidifier's plug is pushed
not start completely into the outlet.
• Check the house fuse/circuit breaker box.
• The dehumidifier has reached its pre-set level
or the water collector is full.
• The water collector is not in the proper position.
The • Did not allow enough time to remove the
dehumidifier moisture.
does not dry
• Make sure there are no curtains, blinds or
the air as it
furniture blocking the front or back of the
should
dehumidifier.
• The humidity selector may not be set low enough.
• Check that all doors, windows and other openings
are securely closed.
• Room temperature is too low, below 5º C (41º F).
• There is a kerosene heater or something giving
off water vapor in the room
The unit • The air filter is clogged.
makes a loud
• The unit is tilted instead of upright as it should be.
noise when
• The floor surface is not level.
operating
Frost appears • This is normal. The unit has an Auto defrost
on the coils feature.
There is water • The hose to the connector or the hose connection
on the floor may be loose.
• It is intended to use the collector to collect water,
but the back drain plug is removed.
The design and specifications are subject to change without prior
notice for product improvement. Consult the sales agency or
manufacturer for details.
29
EN
KDH4756