Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Refer to the following steps and diagram to set up your HDMI matrix switch installation.
Note: Before making any connections, make sure power to all devices connected to the switch is turned off.
1
...........
HDMI Source 1
1
Connect up to 8 (B302-8HX8H-4K) or 4 (B302-4HX4H-4K) HDMI sources to the switch with user-supplied cables.
2
Connect up to 8 (B302-8HX8H-4K) or 4 (B302-4HX4H-4K) HDMI displays to the switch with user-supplied cables.
3
(Optional) Connect up to 8 (B302-8HX8H-4K) or 4 (B302-4HX4H-4K) speakers or amplifiers to the switch with user-
supplied 3.5 mm audio cables.
4
(Optional) Connect a PC or laptop to the RS-232 port to control the switch via RS-232 commands.
5
(Optional) Connect a PC or laptop to the TCP/IP port with a user-supplied Cat6 cable to control the switch via the GUI.
6
(Optional) Connect the included IR Receiver Cable to the IR EXT port.
7
Connect the included power supply to the 12V DC port and turn on the power using the power switch. Within 20–30
seconds, each input signal will be displayed with its corresponding output port.
4
5
6
RS-232 and RJ45
IR Extender
Equipped PC
HDMI Source 8
3
HDMI Display 1
..........
Amplifier 1
Amplifier 8
4
2
HDMI Display 8
..................
4K/60Hz
4K/60Hz
7
12V Power Adapter
Publicidad
Tabla de contenido
