Tabla de contenido
Publicidad
2
Carefully lift tunnel
assembly and
position it at the
desired location
making sure it is level.
Press firmly for 10
seconds at each
clip location along
the length of the
assembly to secure
the clips
clip
16
All manuals and user guides at all-guides.com
3
15
16
and
15
to the wall.
15
Peel the
tunnels
17
away from
the clips
and
15
17
.
16
17
4
15
Arrange cables on
either side of the clips.
Reattach tunnels
to clips
, capturing the
17
16
cables behind them.
Press firmly along the
16
length of the tunnels
where the clips are
located until clips
snap in place.
NOTE: Leave enough
slack in the cables above the
tunnel to prevent them from
interfering with or rubbing
17
against the tunnel when
moving the TV. This could
cause the tunnel to separate
from the clips.
TIP: Use tape the hold the
cables in place during install.
17
and clip
15
19
Publicidad
Tabla de contenido
